Revo RELPTZ22-3 User Manual - Manual (Page 33)

REVO America www.revoamerica.com RELPTZ22-3
31
The View Angle Setup menu enables you to set flip angle and tilt limit.
FLIP:
OFF/AUTO.
OFF: The dome camera moves until it reaches 90° vertically.
AUTO: When the camera reaches the floor directly above the moving
object, it stops. At that time, release the joystick instantly and pull it
down again to run the auto-flip function.
TILT LIMIT:
This option limits the view angle when there is an obstruction in zooming
out on specific area of the tilt angle.
ON: When this option is enabled, the range of the tilt angle will be
limited to 10°.
This will prevent a viewing obstruction or focus problem caused by the
horizontal line of the semi-sphere in the bubble.
OFF: When this option is disabled, the range of the tilt angle will not be
limited.
When you zoom out within the range of the tilt angle, you will see the
horizontal line of the semi-sphere in the bubble.
INITIALIZE DATA The Initialize Data submenu will allow you to reset some or all of the
factory default settings and erase any programming that you have
done.
CAUTION
Use care when accessing the Initialize Data menu. Depending upon your selections, it
will erase all your custom settings.
INITIALIZE DATA
FACTORY DEFAULT
ERASE PROGRAMMED DATA
PRESET FOCUS DEFAULT
EXIT(ESC TO EXIT)