Thermo Fisher Scientific CyberScan pH 1100/pH 2100 - Manual (Page 53)

Instruction Manual pH 1100/ 2100
53
10.5.6 Communication setup mode P4.4
Use this program to set parameters of serial communication.
1. Enter meter setup mode as described in steps 1-4 in Section
10.5.1 Entering meter setup mode (page 50).
2. Use
∆/MI key to scroll to program Tx/Rx Parameter: P4.4.
See Figure 175.
3. Press
ENTER to enter program Tx/Rx Parameter: P4.4.
4. Press
>/CALkey to toggle between Baud Rate 4800, 9600 and
19200. The selection will flash. See Figure 176. Press ENTER
to confirm selection and go to the next setup screen.
5. Press
>/CALkey to toggle between Stop Bit One and Two.
The selection will flash. See Figure 177. Press ENTER to
confirm selection and go to the next setup screen.
6. Press
>/CALkey to toggle between Parity Bit None, Odd and
Even. The selection will flash. See Figure 178.
7. Press
ENTER to confirm selection and return to the setup mode.
Press
∆/MI key to continue to the next setup program, or press
∇/MR to go to the previous program. Press EXIT to return to
measurement mode.
10.5.7 Data transfer setup mode P4.5
1. This program lets you select what data is sent to your printer or
computer.
2. Enter meter setup mode as described in steps 1-4 in Section
10.5.1Entering meter setup mode (page 50).
3. Use
∆/MI key to scroll to program Data Transfer: P4.5. See
Figure 179.
4. Press
ENTER to enter program Data Transfer: P4.5.
5. Press
>/CALkey to toggle between Data send to printer Current
and Memory. .The selection will flash.
See Figure 180.
6. Press
ENTER to confirm selection and return to the setup mode.
Press
∆/MI key to continue to the next setup program, or press
∇/MR to go to the previous program. Press EXIT to return to
measurement mode.
Stop Bit: One Two
Baud Rate
4800 9600 19200
Tx/Rx Parameter:P4.4
Press ENT. to Select
Parity Bit:
None Odd Even
Figure 175
Figure 176
Figure 177
Figure 178
Data send to printer
Current Memory
Data Transfer :P4.5
Press ENT. to Select
Figure 179
Figure 180