West Control Solutions N6600 - Manual (Page 91)

example, the code for a thermocouple input, relay primary output (Output 1) and
relay Output 3 would be 2101.
NOTE: It is essential that this code is changed promptly whenever there is a
change to the Controller’s hardware configuration (change of input/output
type, alarm/recorder output added/removed etc.). The Controller software
depends upon this code to ensure that the Controller operates correctly.
This code may be viewed as a Read Only display in Operator Mode (see Volume
1, Subsection 2.16).
3.2.2 Option Selection
This indicates the option fitted (if any). Using the Raise/Lower keys, the display may
be set to one of:
The displayed option selection may be adjusted (and new values confirmed) as
described previously.
S075-3 3-4
PM-0075