West Control Solutions Pro-8 User Manual
Industrial controller pro-8
Advertising
Table of contents
Document Outline
- Contents
- 1 Mounting 5
- 2 Electrical connections 7
- 3 Operation 12
- 3.1 Front view 12
- 3.2 Behaviour after power-on 13
- 3.3 Operating level 13
- 3.4 Maintenance manager / Error list 14
- 3.5 Self-tuning 16
- 3.5.1 Preparation before self-tuning 16
- 3.5.2 Self-tuning start 17
- 3.5.3 Self-tuning cancellation 17
- 3.5.4 Acknowledgement of failed self-tuning 17
- 3.5.5 Optimization after start-up or at the set-point 17
- 3.5.6 Selecting the method ( ConF/ Cntr/ tunE) 18
- 3.5.7 Optimization at the set-point for 3-point stepping controller 21
- 3.5.8 Examples for self-tuning attempts 22
- 3.6 Manual tuning 23
- 3.7 Second PID parameter set 24
- 3.8 Alarm handling 25
- 3.9 Operating structure 27
- 4 Configuration level 28
- 4.1 Configuration survey 28
- 4.2 Configurations 29
- 4.3 Set-point processing 38
- 4.4 KS50-1 cooling functions 38
- 4.5 Configuration examples 41
- 4.5.1 On-Off controller / Signaller (inverse) 41
- 4.5.2 2-point and continuous controller (inverse) 42
- 4.5.3 3-point and continuous controller 43
- 4.5.4 3-point stepping controller (relay & relay) 44
- 4.5.5 D - Y - Off controller / 2-point controller with pre-contact 45
- 4.5.6 KS50-1 with measured value output 46
- 5 Parameter setting level 48
- 6 Calibration level 53
- 7 Programmer 56
- 8 Special functions 57
- 9 BlueControl 61
- 10 Versions 62
- 11 Technical data 64
- 12 Safety hints 67
- Index
- 0-9
- A
- B
- BlueControl 61
- Boost function 58
- Bus interface
- C
- Calibration level (CAL) 53 - 55
- Certifications 66
- Configuration examples
- Configuration level
- Connecting diagram 7
- Connecting examples
- Control inputs di1, di2, di3
- Cooling functions
- Current signal measuring range 64
-
- Digital inputs di1, di2, di3
- E
- F
- I
- Input INP1
- Input INP2
- Input scaling 52
- L
- M
-
- Offset correction 54
- Optimization at the setpoint 19
- Output OUT1
- Output OUT2
- Output OUT3
- Output OUT5
- Output OUT6
- P
- Parameter setting level
- Power supply 65
- Programmer
- R
- S
- T
- V