West Control Solutions N8840 User Manual
Profiler 8840
Advertising
Table of contents
Document Outline
- Content2
- 1. Mounting 5
- 2. Electrical connections 6
- 3. Operation 11
- 3.1 Front view 11
- 3.2 Behaviour after power-on 12
- 3.3 Operating level 12
- 3.4 Error list / Maintenance manager 13
- 3.5 Self-tuning 15
- 3.5.1 Preparation for self-tuning 16
- 3.5.2 Optimization after start-up or at the set-point 16
- 3.5.3 Selecting the method ( ConF / Cntr / tunE ) 17
- 3.5.4 Self-tuning start 21
- 3.5.5 Self-tuning cancellation 22
- 3.5.6 Acknowledgement procedures in case of unsuccessful self-tuning 22
- 3.5.7 Examples for self-tuning attempts 23
- 3.6 Manual self-tuning 24
- 3.7 Second PID parameter set 25
- 3.8 Alarm handling 26
- 3.9 Operating structure 28
- 4. Configuration level 29
- 4.1 Configuration survey 29
- 4.2 Adjustment: 29
- 4.3 Configuration parameters 30
- 4.4 Set-point processing 47
- 4.5 8840 profiler cooling functions 48
- 4.6 Configuration examples 49
- 4.6.1 On-Off controller / Signaller (inverse) 49
- 4.6.2 2-point controller (inverse) 50
- 4.6.3 3-point controller (relay & relay) 51
- 4.6.4 3-point stepping controller (relay & relay) 52
- 4.6.5 Continuous controller (inverse) 53
- 4.6.6 D - Y - Off controller / 2-point controller with pre-contact 54
- 4.6.7 8840 profiler with measured value output 55
- 4.6.8 Continuous controller with integrated positioner ( Cntr/ C.Fnc = 6 ) 56
- 5. Parameter setting level 57
- 6. Calibration level 62
- 7. Programmer level 65
- 8. Special functions 75
- 9. 8800/8840 Configurator 77
- 10. Versions 78
- 11. Technical data 79
- 12. Safety hints 84
- 13. Notes 88
- Index
- 0-9
- A
- B
- C
- D
- E
- F
- I
- L
- M
- O
- P
- R
- S
- T
- V