West Control Solutions N8840 - Manual (Page 44)

1 with current and voltage input signals, scaling is required (see chapter 5.3)
Configuration level
Configuration parameters 44 8840 profiler
Name Value range Description Default
FrEq Switching 50 Hz / 60 Hz (only visible with 8800/8840
Configurator!)
0
0 50 Hz
1 60 Hz
ICof Block controller off (only visible with 8800/8840
Configurator!)
0
0 Released
1 Blocked
IAda Block auto tuning (only visible with 8800/8840
Configurator!)
0
0 Released
1 Blocked
IExo Block extended operating level (only visible with
8800/8840 Configurator!)
0
0 Released
1 Blocked
ILat Suppression error storage 0
0 Released
1 Blocked
PTmp Block temporary programm changes 0
0 Released
1 Blocked
pPre Block Preset to end and reset 0
0 Released
1 Blocked
pRun Block Run / Stop 0
0 Released
1 Blocked
pSwi Block switch-over to controller 0
0 Released
1 Blocked
pCom Block general p rogram-parameter (b.lo, b.Hi, d.00) 0
0 Released
1 Blocked
Pass OFF...9999 Password (only visible with 8800/8840 Configurator!) OFF
IPar Block parameter level
(only visible with 8800/8840 Configurator!)
0
0 Released
ICnf Block configuration level
(only visible with 8800/8840 Configurator!)
0
0 Released
1 Block
ICal Block calibration level
(only visible with 8800/8840 Configurator!)
0
0 Released
1 Blocked