West Control Solutions Pro-4 User Manual
West Control Solutions Equipment
Advertising
Table of contents
Document Outline
- Contents
- 1 Mounting 5
- 2 Electrical connections 6
- 3 Operation 11
- 3.1 Front view 11
- 3.2 Behaviour after power-on 12
- 3.3 Operating level 12
- 3.4 Error list / Maintenance manager 13
- 3.5 Self-tuning 16
- 3.5.1 Preparation for self-tuning 16
- 3.5.2 Optimization after start-up or at the set-point 17
- 3.5.3 Selecting the method ( ConF / Cntr / tunE ) 17
- 3.5.4 Step attempt after start-up 18
- 3.5.5 Pulse attempt after start-up 18
- 3.5.6 Optimization at the set-point 18
- 3.5.7 Optimization at the set-point for 3-point stepping controller 20
- 3.5.8 Self-tuning start 21
- 3.5.9 Self-tuning cancellation 21
- 3.5.10 Acknowledgement procedures in case of unsuccessful self-tuning 22
- 3.5.11 Examples for self-tuning attempts 23
- 3.6 Manual self-tuning 24
- 3.7 Second PID parameter set 25
- 3.8 Alarm handling 26
- 3.9 Operating structure 28
- 4 Configuration level 29
- 4.1 Configuration survey 29
- 4.2 Configuration parameters 30
- 4.3 Set-point processing 43
- 4.4 Switching behaviuor 44
- 4.5 Configuration examples 47
- 4.5.1 On-Off controller / Signaller (inverse) 47
- 4.5.2 2-point controller (inverse) 48
- 4.5.3 3-point controller (relay & relay) 49
- 4.5.4 3-point stepping controller (relay & relay) 50
- 4.5.5 Continuous controller (inverse) 51
- 4.5.6 D - Y - Off controller / 2-point controller with pre-contact 52
- 4.5.7 Continuous controller with position controller 53
- 4.5.8 Measured value output 54
- 5 Parameter setting level 55
- 6 Calibration level 61
- 7 Special functions 64
- 8 BlueControl 71
- 9 Versions 72
- 10 Technical data 73
- 11 Safety hints 77
- Index
- 0-9
- A
- B
- Bargraph 11
- BlueControl 71
- Bus interface
- C
- Calibration level (CAL) 61 - 63
- Certifications 75
- Configuration examples
- Configuration level
- Connecting diagram 6
- Connecting examples
- Control inputs di1, di2, di3
- Cooling functions
- Current signal measuring range 73
- D
- DAC 64 - 65
- Digital inputs di1, di2, di3
- E
- F
- I
- Input INP1
- Input INP2
- Input INP3
- Input scaling 59 - 60
- L
- M
- O
- O2-measurement 66
- Offset correction 61
- Optimization at the setpoint 18
- Output OUT1
- Output OUT2
- Output OUT3
- Output OUT4
- Output OUT5
- Output OUT6
- Oxygen measurement 66
- P
- Parameter setting level
- Power supply 74
- S
- T
- V