West Control Solutions Pro-4 - Manual (Page 41)

Configuration level
KS 90-1 / KS 92-1 41 Configuration parameters
Name Value range Description Default
LED Function allocation of status LEDs 1 / 2 / 3 / 4 0
10 OUT1, OUT2, OUT3, OUT4
11 Heating, alarm 1, alarm 2, alarm 3
12 Heating, cooling, alarm 1, alarm 2
13 Cooling, heating, alarm 1, alarm 2
14 Bus error
dISP 0...10 Display luminosity 5
C.dEl 0..200 Modem delay [ms]
Additional delay time, before the received message is evaluated in
the Modbus. This time is required, unless messages are transferred
continuously during modem transmission.
0
FrEq Switching 50 Hz / 60 Hz (only visible with BlueControl!) 0
0 50 Hz
1 60 Hz
MAst Modbus master/slave (see page ) (visible only with BlueControl ® ) 0
0 No
1 Yes
CycL 0...240 Master cycle (sec.) (see page ) (visible only with BlueControl ® !) 120
AdrO -32768...3276
7
Destination address (see page ) (visible only with BlueControl ® !) 1100
AdrU -32768...3276
7
Source address (see page ) (visible only with BlueControl ® !) 1100
Numb 0...100 Number of data (see page ) (visible only with BlueControl ® !) 1
ICof Block controller off (only visible with BlueControl!) 0
0 Released
1 Blocked
IAda Block auto tuning (only visible with BlueControl!) 0
0 Released
1 Blocked
IExo Block extended operating level (only visible with BlueControl!) 0
0 Released
1 Blocked
ILat Suppression error storage (visible only with BlueControl ® !) 0
0 No: error message remain in the error list until
acknowledgement.
1 Yes alarms are deleted from the error list as soon as
corrected
Pass OFF...9999 Password (only visible with BlueControl!) OFF
IPar Block parameter level (only visible with BlueControl!) 0
0 Released
1 Blocked
ICnf Block configuration level (only visible with BlueControl!) 0
0 Released
1 Block
ICal Block calibration level (only visible with BlueControl!) 0
0 Released
1 Blocked