West Control Solutions Pro-8 - Manual (Page 30)

Name Value range Description Default
CYCL
Characteristic for 2-point- and 3-point-controllers 0
0 standard
1 water cooling linear
2 water cooling non-linear
3 with constant cycle
tunE
Auto-tuning at start-up 0
0 At start-up with step function
1 At start-up with impulse function. Setting for fast controlled systems
(e.g. hot runner control)
2 Always step attempt during start-up
Strt
Start of auto-tuning 0
0 no automatic start (manual start via front interface)
1 Manual or automatic start of auto-tuning at power on or when
oscillating is detected
Adt0 Optimization of T1, T2 (only visible with BlueControl!) 0
0 Automatic optimization
1 No optimization
InP.1
Name Value range Description Default
S.tYP
Sensor type selection 1
0 thermocouple type L (-100...900°C) , Fe-CuNi DIN
1 thermocouple type J (-100...1200°C) , Fe-CuNi
2 thermocouple type K (-100...1350°C), NiCr-Ni
3 thermocouple type N (-100...1300°C), Nicrosil-Nisil
4 thermocouple type S (0...1760°C), PtRh-Pt10%
5 thermocouple type R (0...1760°C), PtRh-Pt13%
20 Pt100 (-200.0 ... 100,0 °C)
21 Pt100 (-200.0 ... 850,0 °C)
22 Pt1000 (-200.0 ... 850.0 °C)
23 special 0...4500 Ohm (pre-defined as KTY11-6)
30 0...20mA / 4...20mA
Scaling is required. (see chp.5.3 page 51)
40 0...10V / 2...10V
Scaling is required. (see chp. 5.3 page 51)
S.Lin
Linearization (only at
S.tYP
= 23 (KTY 11-6), 30
(0..20mA) and 40 (0..10V) adjustable)
0
0 none
1 Linearization to specification. Creation of linearization table with
BlueControl (engineering tool) possible. The characteristic for
KTY 11-6 temperature sensors is preset.
Corr
Measured value correction / scaling 0
0 Without scaling
1 Offset correction (at CAL level)
2 2-point correction (at CAL level)
3 Scaling (at PArA level)
Configuration level
Configurations 30
Pro-8
Pro-8