Badger Meter ORION Classic (CE) - Manual (Page 30)

ORION® Water Endpoints
3 . Rotate the endpoint counter-clockwise 1/4 turn and pull the endpoint and endpoint wire out from the assembly base .
Figure 30: Rotate endpoint clockwise
Figure 31: Pull endpoint away from base
4 . Mount the endpoint according to recommended installation guidelines using the three feet of wire . See "Endpoint
Installation Guidelines" on page 7 .
NOTE: N The encoder cannot be removed from the assembly housing .
5 . Remount the encoder in the assembly housing onto the meter bayonet .
• Turn the assembly clockwise 1/4 turn so it locks in place .
• Replace and tighten the security screw .
Page 30 June 2014