Description, Features, Unpacking & inspection – Badger Meter Research Control Valve User Manual

Page 5: Storage, Identification label, Description 5

Advertising
background image

DESCRIPTION

The EVA-100 and EVA-200 are multi-featured actuators with the capability to accept analog control signals The design

provides smooth, highly accurate positioning, with positive position-lock when not in motion These rugged actuators

will withstand the most adverse environmental conditions

The EVA-100 and EVA-200 were developed specifically to fit all

RESEARCH CONTROL Valves including the larger Model 9000 and 9100 Their accurate positioning and high thrust makes

them well suited for all research and process applications

Features

• Microprocessor-controlled, linear stepper motor
• 4…20 mA, 0…5V DC, 0…10V DC analog inputs
• Position 4-20 mA analog output
• Incremental Control Input (On/Off control)
• Choice of 100 pound or 200 pound thrust units
• Accurate and repeatable positioning
• Adjustable split range
• Quick and simple zero and span input and output adjustments
• Adjustable stroke up to 1 inch
• User selectable; direct or reverse action
• Controlled seating force to prevent innervalve damage
• Rugged epoxy coated aluminum housing
• 120V AC, 240V AC operation

Unpacking & Inspection

Upon opening the shipping container, visually inspect the product and applicable accessories for any physical damage such

as scratches, loose or broken parts, or any other sign of damage that may have occurred during shipment

OTEE:

N

If damage is found, request an inspection by the carrier’s agent within 48 hours of delivery and file a claim with the

carrier A claim for equipment damage in transit is the sole responsibility of the purchaser

Storage

If the product will not be installed immediately, it should be stored in a clean, dry area where the ambient temperature is not

less than –20° F The actuator should be stored in a non-corrosive environment The actuator is not sealed to NEMA 4 until the

conduit entries are properly connected

Identification Label

An identification label is attached to each actuator cover When ordering parts, requesting information or service assistance,

provide all of the label information

User Manual

Page 5

February 2014

Advertising