Overview, Introduction – Crystal DataLoggerXP Digital Pressure Gauge Software User Manual
Page 3
Overview
1
XP2i Operation Manual
Overview
—
IntroductIon
Thank you for choosing the XP2i Digital Test Gauge from Crystal Engineering Corporation. Your XP2i is a combination of leading edge technology and rugged
industrial design.
Accuracy is 0.1 percent of reading–so any XP2i can typically replace several gauges you may have been using. The XP2i is fully temperature compensated–so
there is no change in accuracy throughout the entire operating temperature range!
The XP2i’s case is made from rugged aluminum alloy utilizing a gasket to seal the enclosure against dust and water intrusion. Even the RS-232 connector is
fully sealed (with or without the red cover or rubber boot). Circuitry is mounted in shock absorbing elastomer supports and the batteries are easily accessible
by removing four screws. But you won’t need to change the batteries often, since 3 AA batteries operate the XP2i for up to 1500 hours of continuous use.
Other features include:
•
Continuous capture of peak and valley pressure readings
•
PSV mode
•
Programming interface
•
User-defined units
•
Intrinsically Safe
•
All welded 316 stainless steel sensor
We hope your XP2i meets your expectations, and we're interested in any comments or suggestions you may have. You can send us a note at:
Many features in this and our other products are a direct result of your comments!
Crystal Engineering is the company that designs, manufactures, markets, and services the nVision reference pressure recorder, XP2i, and 30 series pressure
calibrators, M1 Pressure Gauge, MultiCal multimeter pressure adapters, and a variety of industry specific pressure measuring equipment. Crystal Engineering
pioneered features like full temperature compensation and “of reading” rated gauges and calibrators. Pressure measuring equipment is the only thing we do
and that’s why we say:
™
Your XP2i can be customized, through the use
of our free
™ software. Your personal
computer can disable, enable, or modify a
variety of features of your XP2i. Look for the
logo for
programmable features, like:
•
A user defined pressure scale, and/or disable
unused pressure units
•
Password protection to prevent
unauthorized changes
•
Disable keypad recalibration,
(
peak
)
button, and/or
(
units
)
button
•
Expand or decrease allowable Zero range
•
Set the gauge to a different density of water
factor (4° C, 60° F, or 68° F)
•
Store a 12 digit ID or tag number in
non-volatile memory
•
Adjust calibration values