Dwyer SPPM-HSG - Manual

Series SPPM-HSG Weatherproof Housing
Specifications - Installation and Operating Instructions
Bulletin PC-SPPM-HSG
The Series SPPM-HSG Weatherproof Housing was designed to
protect the Series SPPM programmable panel meters from weather and
tampering. Housings can be factory-configured for either 2.4˝ or 2.8˝
panel meters. For added flexibility, the brackets inside of the housing
can be reversed to fit the other display size. The top bracket swivels on
a hinge to allow access to wiring and the mini-USB port on the panel
meter.
Installation
Step 1) Remove the lid by loosening the four screws in the corners of
the lid (screws should stay captured in the lid).
Step 2) Mount the enclosure to the wall or duct.
Step 3) Unscrew the two screws on the bottom of the panel meter
mounting bracket only (as seen in Figure 1).
Step 4) Slide the panel meter through the center hole of the mounting
bracket.
Step 5) For the 2.4˝ model, lift the bottom of the mounting bracket so
that it swivels up exposing the rear of the panel meter (as seen
in Figure 2) and slide the mounting hardware over the rear of
the meter locking it in place.
Step 6) Bring the wire into the enclosure through the conduit hole at the
bottom of the housing and wire the panel meter according to its
instruction manual (Bulletin PC-SPPM).
Step 7) Replace the two screws on the bottom of the panel meter
mounting bracket.
Step 8) Re-attach the lid and tighten the four screws.
SPECIFICATIONS
Service: Indoor or outdoor.
Material: Painted aluminum and glass.
Enclosure Rating: NEMA 4X (IP66).
DWYER INSTRUMENTS, INC.
Phone: 219/879-8000 www.dwyer-inst.com
P.O. BOX 373 • MICHIGAN CITY, INDIANA 46361, U.S.A. Fax: 219/872-9057 e-mail: [email protected]
©Copyright 2011 Dwyer Instruments, Inc. Printed in U.S.A. 6/11 FR# 03-443915-00
MAINTENANCE/REPAIR
Upon final installation of the Series SPPM-HSG, no routine maintenance
is required. The Series SPPM-HSG is not field serviceable and should
be returned if repair is needed. Field repair should not be attempted and
may void warranty.
WARRANTY/RETURN
Refer to “Terms and Conditions of Sales” in our catalog and on our
website. Contact customer service to receive a Return Goods
Authorization number before shipping the product back for repair. Be
sure to include a brief description of the problem plus any additional
application notes.
A
A
REMOVE THESE
SCREWS TO LIFT
TOP PLATE.
SECTION A-A
107° RANGE
OF MOTION
Figure 1
Figure 2
4-23/32
[120]
4-9/64
[105]
4-23/32
[120] 4-9/64
[105]
Ш7/8
[Ш22]
3-37/6
[91]
1-5/32
[30]
*Shown with Series SPPM Panel Meter sold seperately.