Dwyer 16A - Manual

INSTRUCTIONS FOR OPTIONS 9175 AND 9176
Option 9176: AUTO/MAN Key 4-Stage Set Point Cycling
This option allows the operator to easily cycle through four set points by pressing the
AUTO/MAN key while in the HOME display. They are displayed as 1SP1, 2SP1, 3SP1,
and 4SP1. Only one of these set points may be active at a time. After selecting which
set point is to be active, the operator will press INDEX to access the primary menu
which will allow the user to edit the set point’s value. Each of these set points contain
a target process value, and all of the values associated with the tunE menu items.
Option 9175: Temporary User Adjustable Set Point
This option allows the operator to use a temporary set point, which they can make
changes to without affecting the original stored set point, and then revert back to
original set point after the test is completed. When the temporary set point is
cancelled, the unit discards the temporary set point value and resumes normal
operation.
This temporary set point operates like the originally stored set point, SP1, normally
does. The set point is displayed as tSP1. In order to access the temporary set point,
press the UP or DOWN key while in the home display to bring up a menu where tSP1
can be adjusted. Pressing the ENTER key will confirm the displayed value. Pressing
the INDEX key will exit the menu. After tSP1 is confirmed once, it will become active.
tSP1
can be cancelled by changing and confirming the value of SP1, #SP1, or SP2.
When used in conjunction with option 9176, cycling to the next #SP1 will also cancel
tSP1
. When used with option 948, selecting another #SP1 via the secondary menu will
also cancel tSP1. #SP1 represents the 1SP1 through 4SP1 series of set points.
This option replaces the normal manual override functionality of the
AUTO/MAN key.
NOTICE
FR# 949-9516 Rev. 1