Figure 4-5: ethermate – assign ip address window – Innotech Device Communications User Manual
Page 24
© MASS ELECTRONICS Pty Ltd 2011
DS 99.05 – Ethernet Setup Manual for Device Communications
Page 16
Edition 1.0 dated 04/10/11
4
From the EtherMate tool bar click on
3.
Assign IP to assign an IP address for your
device. The Assign IP Address window will be displayed, as illustrated in Figure 4-5
below. Please note that the IP Address field may automatically populate with an IP
address according to your network configuration.
Enter the IP address and subnet mask you want to assign your Innotech device, and
4.
click on
Assign to save and apply the new settings. Click on OK in the Information
popup window.
From the EtherMate toolbar click on
5.
Search to discover your Innotech device with the
newly configured IP address and subnet mask. You may have to click on it a couple
of times while the device reboots and responds to the request. When the search is
finished, your device should be listed in the left window pane under Ethernet Devices,
as illustrated in Figure 4-6 below.
EtherMate – Assign IP address window
Figure 4-5:
EtherMate – device found with new IP address
Figure 4-6: