Innotech Device Communications - Manual (Page 32)

© MASS ELECTRONICS Pty Ltd 2011
DS 99.05 – Ethernet Setup Manual for Device Communications
Page 24
Edition 1.0 dated 04/10/11
4
Configuring Ethernet settings of IG03 and IG04 with FusionLIVE
The Ethernet settings on the IG03 and IG04 Gateway can be configured and modified
with the embedded FusionLIVE Java interface to suit your LAN requirements. But in
order to initially access the FusionLIVE interface on the IG03 or IG04 out of the box,
you need to configure the network settings of your computer to be on the same network
range as the IG03 or IG04 default factory Ethernet settings.
For detailed instructions on how to configure your computer network settings, please
refer to the Configuring network settings of your computer section.
When you have configured your computer network settings, follow the instructions
below to access the IG01 embedded web server, and edit or modify the default Ethernet
settings of the IG01 to suit your LAN requirements.
Access FusionLIVE on IG03 and IG04 Figure 4-19:
Launch Internet Explorer and enter the default IP address of the IG03 or IG04 1.
(192.168.2.100), as illustrated in Figure 4-19 below.
The embedded server home page will be displayed. Click on the 2.
button to launch the FusionLIVE configuration page, as illustrated in Figure
4-20 below. The Java applet will be downloaded at this time in order to view the
FusionLIVE interface.
Launch FusionLIVE – IG03 and IG04 Figure 4-20:
NOTE
Please note that differences between the IG03 and IG04 web server interface are illustrated and
described as necessary.
NOTE
The Java Runtime Environment (JRE) version 6.1 or greater must be installed on the computer in
order to access the FusionLIVE interface. If you don't have JRE installed on your computer, you will be
prompted to download and install JRE when you connect to an IG03 or IG04 for the first time.