MadgeTech RFOT Wireless Meat Temperature Data Logger - Manual (Page 5)

RFOT Product User Guide
1.
Install the MadgeTech 4 Software and USB Drivers onto a Windows PC.
2.
The RFC1000 interface device comes with a USB cable. Plug one end of the cable into an available USB port on the PC and plug the
opposite end of the cable into the communication port on the RFC1000.
3.
To activate the wireless mode on the RFOT Data Logger, unscrew the end cap and gently separate the end from the body of the logger
2-3 inches. Flip the black switch located inside to the wireless position to 1 (0 indicates non-wireless mode, 1 indicates wireless mode).
Screw the end cap back in place and ensure the fit is tightly sealed.
4.
Launch the MadgeTech 4 Software. All active MadgeTech Data Loggers that are within range will automatically appear in the
connected devices window. Each data logger in the list can be identified by serial number (imprinted on the exterior of the logger).
5.
To claim a device, select the desired data logger in the list and click the Claim icon.
6.
Select the start method, reading rate and any other parameters appropriate for the desired data logging application. Once configured,
deploy the data logger.
7.
To download data, select the device in the list, click the Stop icon, and then click the Download icon. A graph will automatically
display the data.
Quick Start Steps
MadgeTech 4 Software
A Complete Wireless Data Logging System
Data Logger Interface Device &
USB Cable
USB Cable
(Included accessory with RFC1000)
Power Adapter
(Included accessory with RFC1000)
RFOT Wireless Data Logger RFC1000 Wireless
Transceiver
1