NORD Drivesystems BU0300 - Manual (Page 121)

8 Fault messages
BU 0300 EN Subject to technical alterations 121
Display
in the ControlBox Error
text in the Parameter Box
Cause
•
Remedy Group Detail in
P700 / P701
E008 8.0 EEPROM parameter loss
(maximum value exceeded) ) Error in EEPROM data
• Software version of the stored data set not
compatible with the software version of the FI.
NOTE: Faulty parameters are automatically reloaded
(factory setting).
• EMC interferences (see also E020)
8.1 Invalid inverter type
• Un-initialised frequency inverter
8.3 EEPROM CIU not recognised
(interface equipment)
EEPROM not present in adapter unit.
• Switch mains voltage off and on again.
8.4 EEPROM not recognised
internally EEPROM not present in frequency inverter
• Switch mains voltage off and on again.
8.5 No EEPROM recognised No EEPROM memory present in system
• Switch mains voltage off and on again.
8.6 Back-up copy used Internal data used
• Switch mains voltage off and on again.
8.7 Different back-up copy Internal data overwritten
• Switch mains voltage off and on again.
8.8 Empty EEPROM memory Un-initialised EEPROM memory
• Switch mains voltage off and on again.
E009 --- ControlBox error SPI Bus faulty, no communication with ControlBox.
• Check ControlBox for correct position.
• Switch mains voltage off and on again.