Prochem Triad Air Mover - Manual (Page 19)

86333800 TRIAD THRUSTER FAN 19
Maintenance
Stacking
During storage or transporting, fans can be stacked to
minimize required space. Always secure fans in place
with appropriate strapping. Do not stack fans any
more than 4 high.
Never operate fans while they are stacked. This
could result in damage to the motors.
N'actionnez jamais les ventilateurs lorsqu'ils sont
empilés puisque les prises d'entrée d'air seront
recouvertes. Ce qui pourrait endommager les
moteurs.
1. Stack fans by placing the first one with its feet flat
on a level floor. The power cord should be wrapped
around intake nozzle in its standard cord storage
position.
2. Nest the feet of second fan over the intake nozzle
of first one.
3. Strap fans together, and to a stable, strong struc-
ture, especially in a moving truck.
Storing in Warehouse and in Delivery
Truck
Fans can be stored flat on their feet, on their backs, or
on their sides. Always store them inside away from
weather, in an area not exposed to excessive heat or
cold.
It is NOT recommended to stack fans vertically for long
periods of time. To minimize the amount of shelf space
required during storage, place fans on their sides.
Always secure stored fans, especially in a moving
vehicle and or when stacked.
NOTE: Do not store upside down with their intake
nozzle towards the floor or with the exhaust nozzle
pointed towards the floor.
Cleaning Fan
The fan can be wiped down with a cleaning cloth.
Always unplug power and any other attached
components before cleaning. Always keep liquids
away from all electrical components.
Débranchez toujours la prise électrique et tous les
autres composants fixes avant le nettoyage. Tenez
toujours les substances liquides à bonne distance
de tous les composants électriques.
NOTE: The fan is best cleaned after being
disassembled. Never plug in or operate the fan in
any state of disassembly.
1. Remove the motor/fan assembly from main
housing by removing base plates 6 screws.
2. While lowering base plate motor assembly out of
housing, detach the main harness electrical
connector from fan motor.
3. Wipe fan blades, motor mounting plates and inside
of housing.
For further cleaning, remove electrical console:
4. Remove the 4 back and bottom console mounting
screws from inside the housing.
5. Feed harness through holes in housing as it is
removed. The main housing should now be free of
any electrical components and can be safely
cleaned with most cleaning chemicals. High
pressure can also be used to clean housing now.
Do not use high temperature air or liquids on
plastic housing.
6. Finger guards are also bolted on, and can easily be
removed for cleaning.
7. To reassemble, reverse the disassembly steps.
NOTE: Always inspect all parts for damage during
disassembly and reassembly and have an authorized
service center replace any damaged components
with factory replacement parts.
! AVERTISSEMENT:
! AVERTISSEMENT: