Prochem Triad Air Mover - Manual (Page 21)

86333800 TRIAD THRUSTER FAN 21
Maintenance
Replacing Power cord
1. Remove electrical console from main housing
2. Remove screws securing console halves together.
Carefully separate two halves noting wire
placement and routing.
3. Swing console halves open enough to access back
side of power cord.
4. Remove mounting nut from the trumpet shaped
strain relief. Disconnect wires noting location and
connections.
5. Reverse steps while consulting wiring diagram to
reassemble.
Circuit Breaker
1. Remove electrical console from main housing
2. Remove screws securing console halves together.
Carefully separate two halves noting wire
placement and routing.
3. Swing console halves open enough to access back
side of breaker.
4. Before disconnecting circuit breaker note line and
load labeling, it is important that it is reconnected
properly. Disconnect wires from breaker.
5. Remove clear rubber boot on outside of housing
and slide breaker through hole in console.
6. Reverse steps while consulting wiring diagram to
reassemble.
Capacitor
1. Remove electrical console from main housing
2. Remove screws securing console halves together.
Carefully separate two halves noting wire
placement and routing.
3. Swing console halves open enough to access
capacitor, remove.
4. Before disconnecting capacitor, note wire connec-
tions, locations and color / numbers for reas-
sembly. it is important that it is reconnected
properly. Disconnect wires from capacitor.
5. Reverse steps while consulting wiring diagram to
reassemble.