Sterlco Micro Series Water Temperature Control Unit - Manual (Page 16)

3200 Series
16 ACS 3216 Operators Manual
nor Normal 4.SENS SENSE To configure the polarity of
output channel 4
Inv Inverted
nor Conf
LOGIC INPUT LIST ‘l a ’ / ‘LB’
Name Scrolling Display Parameter Description Value Default Access Level
L.TYPE LOGIC INPUT
TYPE Input channel type L.IP Logic input As order
code Conf
Read only
none Input not used
Ac.AL Alarm acknowledge
SP2 Setpoint 2 select
Loc.b Front keypad disable
t.res Timer/programmer reset
t.run Timer/programmer run
t.rrS Timer/programmer run/reset. Make to
run, break to reset
t.HLd Timer/programmer hold
Man Manual status
Sby Standby mode. In this mode control
outputs go to zero demand
rmt To allow a remote setpoint to be
selected through the LA digital input.
rec Recipe select through IO1 digital
input
UP Remote key ‘Up’
L.d.i n LOGIC INPUT
FUNCTION To configure the function of the
digital input
dwn Remote key ‘Down’
Ac.AL Conf
nor Normal
Inv Inverted
L.SENS LOGIC INPUT
SENSE To configure the polarity of the
input channel
4.20 4-20mA output
nor Conf
SETPOINT LIST ‘SP’
Name Scrolling Display Parameter Description Value Default Access Level
SP1 Setpoint 1 selected S P . S E L SETPOINT
SELECT This enables the main or secondary
setpoint to be selected form the front
panel buttons
SP2 Setpoint 2 selected
SP1 L3
S P 1 SETPOINT 1 Main or normally selected setpoint Low to high setpoint limits 0 L3
S P 2 SETPOINT 2 Secondary or standby setpoint Low to high setpoint limits 0 L3
S P . H I SETPOINT HIGH
LIMIT Maximum allowable setpoint setting Setpoint low limit (SP.LO) to high range
limit. Also limited by the rng.hi and
rng.lo parameters Range
High Limit L3
S P . L O SETPOINT LOW
LIMIT Minimum allowable setpoint setting Low range limit to Setpoint high limit
(SP.HI). Also limited by the rng.hi and
rng.lo parameters Range
Low Limit L3
r E m . s p REMOTE
SETPOINT Reads the current remote setpoint value
when remote setpoint is in use Read only
No Not selected l - r REMOTE
SETPOINT
SELECT To select the remote digital
communications setpoint
YES Selected
no Conf
S P . R A T SETPOINT RATE
LIMIT Limits the rate of change of the setpoint.
Operates on both SP1 and SP2 Step change (
OFF) or 0.1 to 3000
display units per minute.
Resolution one decimal place more than
PV
Off L3
min Minutes
Hour Hours
r a m p u SETPOINT RAMP
UNITS To set the units for the setpoint rate limit
SEC Seconds
min L3
l o c . t LOCAL SETPOINT
TRIM To apply a fixed offset to the setpoint in
use -199.9 to 300.0 0.0 L3
R E M . H I REMOTE INPUT
HIGH SCALAR Sets the maximum scale limit for the
remote setpoint
R E M . l o REMOTE INPUT
LOW SCALAR Seta the minimum scale limit for the
remote setpoint
Between Range High and Low Limits L3