AT&T CL82350 - Manual (Page 23)

18
Answering system settings
Call screening
Use this feature to choose whether incoming messages can be heard over
the telephone base speaker when they are being recorded. If you turn call
screening on, you hear the incoming message. While monitoring an incoming
message, you can answer the call by pressing
PHONE/
FLASH
or /SPEA�ER SPEA�ER
on the handset.
To change the setting:
1. When the handset is in idle mode, press
MENU/
SELECT
to
enter the main menu.
2. Press q CID or pDIR to scroll to >Answering sys, then
press
MENU
/SELECT.
3. Press q CID or pDIR to scroll to >Ans sys setup, then
press
MENU
/SELECT.
4. Press q CID or pDIR to scroll to >Call screening, then
press
MENU
/SELECT.
5. Press q CID or pDIR to choose On or Off.
6. Press
MENU
/SELECT to confirm your setting. You hear a
confirmation tone. Press OFF/
CLEAR
to cancel.
NOTE: For more information on call screening, see page 41.
Number of rings
You can set the answering system to answer an incoming call after two, four
or six rings. You can also select toll saver, which is explained on the next page.
Unless you change it, the answering system answers an incoming call after
four rings.
To set the number of rings:
1. When the handset is in idle mode, press
MENU/
SELECT
to
enter the main menu.
2. Press q CID or pDIR to scroll to >Answering sys, then
press
MENU
/SELECT.
3. Press q CID or pDIR to scroll to >Ans sys setup, then press
MENU
/SELECT.
4. Press q CID or pDIR to scroll to ># of rings, then press
MENU
/SELECT.
5. Press q CID or pDIR to scroll and choose among 2, 4, 6 or Toll saver.
> # of rings
Remote code
# OF RINGS
>2
Telephone settings
> Call screening
# of rings
> Ans sys setup
-End of list-
CALL SCREENING
>On
Play messages
> Answering sys