AT&T CL82350 - Manual (Page 35)

30
Create directory entries
To create a new directory entry
1. Press
MENU/
SELECT
in idle mode to enter the main menu.
2. Press q CID or pDIR to scroll to >Directory, then press
MENU
/SELECT.
3. Press q CID or pDIR to highlight Add contact.
4. Press
MENU
/SELECT.
5. Enter the telephone number when prompted.
• Use the dial pad to enter up to 30 digits.
– Press q CID or pDIR to move the cursor to the left
or right.
– Press
MUTE
/DELETE to erase a digit.
– Press and hold
MUTE
/DELETE to erase all digits.
– Press and hold
REDIAL
/PAUSE to enter a three-second
dialing pause (a p appears).
– Copy a number from the redial list by pressing REDIAL/
PAUSE
then
q CID or pDIR, or pressing REDIAL/
PAUSE
repeatedly to locate the
number to copy. Press
MENU
/SELECT to copy the number.
6. Press
MENU
/SELECT to save the number in the display.
The display shows Already saved if the number is already in the directory.
You cannot save the same number twice.
7. Enter the name when prompted.
• Use the dial pad to enter a name (up to 15 characters).
Each time you press a key, the character on that key
appears. Additional key presses produce other characters
on that key. See the chart on the next page.
– Press q
CID or pDIR to move the cursor to the left
or right.
– Press
– Press 0 to add a space.
– Press
MUTE
/DELETE to erase a letter.
– Press and hold
MUTE
/DELETE to erase all letters.
NOTE:
The first letter of every word is a capital letter. The remaining letters in a word start as lower
case letters as shown in the chart on the next page.
You cannot store a new number to a full directory until you delete one. The screen shows
Directory full.
1.
2.
> Directory
Answering sys
REVIEW
>Add contact
ENTER NUMBER
888-883-2445_
ENTER NAME
Robert Brown_
Saved
Directory