Sterlco ST500 Series Central Granulator - Manual (Page 71)

71
MAINTENANCE
SECTION 6-6
Screen Replacement
REPLACE THE SCREEN
Place the screen on the floor close to, and in front of the
machine. Set it on its circular surface with its long
dimension parallel with the machine.
Align one edge with the edge of the machine cradle.
Roll the screen toward you by pushing down on the near
side and then slide it up against the support bar.
Repeat the foregoing steps for each segment of the
screen.
CLOSE THE SCREEN CRADLE INTERLOCK
Engage the interlock screw by turning it clockwise with a
box wrench or a ratchet wrench.
Make sure the interlock actuator screw is fully seated
against the top surface of its housing.
When engaged, the interlock switch closes the electrical control
circuit to the machine and allows it to operate.
CLOSE THE CUTTING CHAMBER SAFETY
INTERLOCK
Engage the safety interlock by turning the
actuator screw clockwise until tight
Make sure the screw is fully seated
When engaged, the interlock closes the electrical
control circuit to the motor and allows the machine to
run.