Configure your machine for a wireless network, Using the setup wizard from the control panel, Important – Brother MFC 8480DN User Manual

Page 42

Advertising
background image

Configuring your machine for a wireless network (For MFC-8690DW and MFC-8890DW)

31

3

Configure your machine for a wireless network

3

IMPORTANT

• If you are going to connect your Brother machine to your network, we recommend that you contact your

system administrator prior to installation. You must know your wireless network settings before you
proceed with this installation.

• If you have previously configured the wireless settings of the machine, you must reset the network LAN

settings before you can configure the wireless settings again. Press Menu, 7, 0 for Network Reset,
press 1 for Reset and then choose 1 for Yes to accept the change. The machine will restart automatically.

Using the Setup Wizard from the control panel

3

You can configure your Brother machine by using the Setup Wizard function. This is located in the
Network

menu on the machine’s control panel. See to the steps below for further information.

a

Write down the wireless network settings of your access point or wireless router. If you do not know them,
contact your network administrator or the manufacture of your access point/router.
Check and record the current wireless network settings.

Network name:(SSID, ESSID)

Communication Mode

Authentication method

Encryption mode

Network key

4

Infrastructure

Open system

WEP

2

NONE

Shared key

WEP

2

WPA/WPA2-PSK

1

AES

TKIP

3

LEAP

CKIP

EAP-FAST/NONE

EAP-FAST/MS-CHAPv2

EAP-FAST/GTC

AES
TKIP

Ad-hoc

Open system

WEP

2

NONE

Advertising
This manual is related to the following products: