Ram expansion, Dimm memory, See 4-12 – Brother HL-2460 User Manual
Page 144
4–12
R
R
A
A
M
M
E
E
x
x
p
p
a
a
n
n
s
s
i
i
o
o
n
n
The HL-2460 printer has 16 Megabytes of standard memory and 2 slots for
optional expansion memory. The memory can be expanded up to 272
Megabytes by installing commercially available dual in-line memory modules
(DIMMs). (The standard memory fitted can vary depending on the printer
model and country.)
The HL-2460N printer has 32 Megabytes of standard memory. The memory
can be expanded up to 272 Megabytes. When you want to upgrade to more
than 160 Mbytes, you will need to remove the already installed 16 Mbytes
DIMM and replace it with a higher capacity DIMM. (The standard memory
fitted can vary depending on the printer model and country.)
The following capacity of DIMM can be installed:
<US>
•
16 Megabytes
TECHWORKS
12456-0001
•
32 Megabytes
TECHWORKS
12457-0001
•
64 Megabytes
TECHWORKS
12458-0001
•
128 Megabytes
TECHWORKS
12459-0001
<Europe>
•
16 Megabytes
BUFFALO TECHNOLOGY
12323-0001
•
32 Megabytes
BUFFALO TECHNOLOGY
12324-0001
•
64 Megabytes
BUFFALO TECHNOLOGY
12325-0001
•
128 Megabytes
BUFFALO TECHNOLOGY
12326-0001
In general, the DIMM must have the following specifications:
Type:
100 pin and 32 bit output
CAS Lantency:
2 or 3
Clock Frequency:
66MHz or more
Capacity:
16, 32, 64 Megabyte or 128 Megabyte
Height:
46mm (1.8 inches) or less
Parity:
NONE
Dram Type:
SDRAM 4 Bank
SDRAM can be used.
✒
Note
•
For more information, consult the dealer where you purchased the
printer.
•
For the latest information, visit the Brother Solutions Center at