Safety information – Brother HL-2460 User Manual
Page 16
xv
Safety Information
IMPORTANT - For Your Safety
To ensure safe operation the three-pin plug supplied must be inserted only into a standard
three-pin power point which is properly grounded through the normal household wiring.
Extension cords used with this printer must be three-pin plug type and correctly wired to
provide proper grounding. Incorrectly wired extension cords may cause personal injury an
equipment damage.
The fact that the equipment operates satisfactorily does not imply that the power is
grounded and that the installation is completely safe. For your safety, if in any doubt about
the effective grounding of the power, consult a qualified electrician.
Disconnect device
This printer must be installed near a power outlet that is easily accessible. In case of
emergencies, you must disconnect the power cord from the power outlet to shut off the
power completely.
Geräuschemission / Acoustic Noise Emission (For Germany Only)
Lpa < 70 dB (A) DIN 45635-19-01-KL2
Wiring Information (For U.K. Only)
Important
If the mains plug supplied with this printer is not suitable for your socket outlet, remove the
plug from the mains cord and fit an appropriate three pin plug. If the replacement plug is
intended to take a fuse then fit the same rating fuse as the original.
If a moulded plug is severed from the mains cord then it should be destroyed because a
plug with cut wires is dangerous if engaged in a live socket outlet. Do not leave it where a
child might find it!
In the event of replacing the plug fuse, fit a fuse approved byASTA to BS1362 with the
same rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - THIS PRINTER MUST BE EARTHED
The wires in the mains cord are coloured in accordance with the following code :
GREEN AND YELLOW :
EARTH
BLUE :
NEUTRAL
BROWN :
LIVE
The colours of the wires in the mains lead of this printer may not correspond with the
coloured markings identifying the terminals in your plug.
If you need to fit a different plug, proceed as follows.