Brother PT-7500 - Manual (Page 25)

10
Notes on tape cassettes
☞ Before installing the tape cassette, make sure that the end of the tape feeds under the tape
guides.
☞ If the tape cassette to be installed has an ink ribbon and the ink ribbon is loose, use your
finger to wind the toothed wheel in the direction of the arrow on the cassette until there
is no slack in the ribbon.
☞ When inserting the tape cassette, make sure that the inner ribbon does not catch on the
corner of the metal guide.
☞ After installing a tape cassette and installing the back cover, press
f
once to remove
any slack in the tape, and then press the tape cutter button to cut off the excess tape.
☞ Always cut off the tape before removing it from the machine. If the tape is pulled on
before being cut off, the tape cassette may be damaged.
Extra Strength Adhesive Tape
☞ For textured, rough, or slipping surface, we recommend using Extra Strength Adhesive
Tape.
☞ Although the instruction sheet included with the Extra Strength Adhesive
Tape cassette recommends cutting the tape with scissors, the tape cutter
that this P-touch labeler is equipped with is able to cut Extra Strength
Adhesive Tape.
End of the tape Tape guide
Toothed wheel