Setting the user bit 78, User bit output 78, Cop y – Canon XA25 User Manual

Page 78: Setting the user bit

Advertising
background image

Setting the User Bit

78

Setting the User Bit

The user bit display can be selected from the date or the time of recording, or an identification code
consisting of 8 characters in the hexadecimal system. There are sixteen possible characters: the
numbers 0 to 9 and the letters A to F. When you record a scene, the user bit will be recorded with it.
The user bit is also output from the HD/SD-SDI terminal (

only) or HDMI terminal.

1 Open the user bit [Setting] screen.

[FUNC.]

>

[MENU]

>

>

[User Bit Type]

>

[

Setting]

• To set the time for the user bit, select [

Time] instead; to set the date for the user bit, select

[

Date]. In such case, the rest of the procedure is not necessary.

• The user bit setting screen will appear with the orange selection frame on the leftmost digit.

• To reset the user bit to [00 00 00 00], touch [Reset] and then touch [X].
• Touch [Cancel] to close the screen without setting the user bit.

2 Touch [

Í] or [Î

] to change the digit as necessary.

3 Touch another digit you want to change.

4 Change the rest of the digits in the same way.

5 Touch [OK] and then touch [X].

User Bit Output

When the frame rate is set to 23.98P and

>

[User Bit Output Mode] is set to [Pulldown], the

user bit will be 2:3 pulldown data.

NOTES

• When playing back MP4 movies, the user bit embedded in the signal output from the HD/SD-SDI

terminal (

only) and HDMI terminal will have a value of 0 and cannot be changed.

Operating modes:

COP

Y

Advertising
This manual is related to the following products: