Canon PowerShot A2600 - Manual (Page 111)

111
ç Contents ç Chapter Contents
Still Images
Shooting with Servo AF
This mode helps avoid missing shots of subjects in motion,
because the camera continues to focus on the subject and adjust
the exposure as long as you press the shutter button halfway.
1
Configure the setting.
z z Press the < n> button,
choose [Servo AF] on the [ 4]
tab, and then choose [On]
( = 55 ).
2
Focus.
z z The focus and exposure are
maintained where the blue AF
frame is displayed while you
are pressing the shutter button
halfway.
• Focusing may not be possible in some shooting conditions.
• In low-light conditions, Servo AF may not be activated
(AF frames may not turn blue) when you press the shutter
button halfway. In this case, the focus and exposure are
set according to the specified AF frame mode.
• If adequate exposure cannot be obtained, shutter speeds
and aperture values are displayed in orange. Release the
shutter button, and then press it halfway again.
• AF lock shooting is not available.
• [AF-Point Zoom] on the [ 4] tab is not available.
• Not available when using the self-timer ( = 71 ).