Canon imagePROGRAF iPF6400S - Manual (Page 946)

Cut sheets cannot be pulled out from the front paper feed slot Cut sheets cannot be pulled out from the front paper feed slot
Cause Corrective Action
You have loaded
paper other than
POP board. Push the cut sheet from the front side of the printer towards the back side. Once the edge of the cut sheet protrudes from
the back side of the printer, pull it out from the back side.
Roll paper cannot be inserted into the paper feed slot Roll paper cannot be inserted into the paper feed slot
Cause Corrective Action
The roll paper is warped. Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot. Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
➔ P.938
(See "Clearing a Jammed Sheet, Fed Manually.") ➔ P.941
After a roll was advanced, the paper was manually pulled out by force, closing the
Paper Feed Slot. Remove the roll and open the paper feed slot.
(See "Removing the Roll from the Printer.")
➔ P.514
Cannot load sheets Cannot load sheets
Cause Corrective Action
The paper source selection is incorrect. Press the Load button and select the paper source.
Paper is not cut neatly Paper is not cut neatly
Cause Corrective Action
The paper is bent or curled at the cut position. Straighten out any curling by the edges of the paper.
Paper rises by the ends of the cut position before it is
cut. Reload the paper correctly.
You are using paper that cannot be cut with the Cut-
ter Unit. Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a cut-
ting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")
➔ P.520
Cut Speed is not configured correctly in the Control
Panel menu. Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")
➔ P.628
During cutting, printed documents fall out at an an-
gle. In the Control Panel menu, set Cutting Mode to Eject. Hold documents after printing,
as they are cut.
(See "Specifying the Cutting Method for Rolls.")
➔ P.520
Paper is not cut Paper is not cut
Cause Corrective Action
The printed document became caught on a foreign object by the
Output Tray, which lifted the document. The Cutter passed under
the paper. Remove the foreign object by the Output Tray to enable the printer to
eject the printed document, keeping it level.
In the printer driver, No or Print Cut Guideline is specified in Au-
tomatic Cutting. Specify Yes in Automatic Cutting in the printer driver.
Cut sheets cannot be pulled out from the front paper feed slot iPF6400S
User's Guide
Troubleshooting
Problems Regarding Paper
946