Canon VB-C300 - Manual (Page 28)

2-4
Connect the Camera to the Network and Perform the Initial Setting
Connect the Camera to the Network and Turn the Power Supply On
First, connect the camera to the network. Connect the camera and PC via the HUB with a LAN
cable, connect the camera to the network, then turn the power on. If 20 minutes have passed since
the VB-C300 was turned on, it can no longer be detected by the VB Initial Setup Tool (
➝ P.2-7). In
this case, turn the camera OFF then ON again.
The VB-C300 is equipped with the PoE (Power over Ethernet) function. The power can be supplied
to the camera via the LAN cable from an IEEE 802.3af-compliant PoE HUB.
When using PoE HUB
(Rear)
AC power cable
Notebook PC
PoE HUB
LAN cable
B A
OUT IN-2 IN-1
100/10BT VIDEO
OUT
LINE IN DC IN 12-13V
AC IN 24V LINE
OUT
When using the AC adapter (optional) or external power supply, connect them as shown below.
B A
OUT IN-2 IN-1
100/10BT VIDEO
OUT
LINE
IN
DC IN 12-13V
AC IN 24V LINE
OUT
Notebook PC
HUB
(Rear)
AC power cable
AC Adapter
LAN cable
When using the AC Adapter (Optional) or external power supply
The figure shows the AC adapter (optional).