Electrolux EW30DS75KS - Manual (Page 47)

47 Care and Cleaning
• Do not close the oven door until all the interior
oven racks are fully inserted and retracted to
the back of the oven.
• Do not hit the glass with pots, pans, or any
other object. The oven door glass may break or
even break at a later time unexpectedly.
• Scratching, hitting, jarring or stressing the oven
door glass may weaken its structure causing
an increased risk of breakage at a later time.
• You may use a glass cleaner on the outside
of the oven door glass. Do not spray or allow
water or the cleaner to enter or drip down into
the oven door vents. Spray cleaner on cloth
first and then wipe the oven door clean.
• Do not use strong oven cleaners, powders or
any harsh abrasive cleaning materials on the
outside of the oven door or glass.
• Never clean the oven door gasket. The oven
door gasket should always clean during the
Self-clean cycle.
Special door care instructions Changing oven lights
The oven light bulbs are located on both side of
the oven cavity and both are covered with a glass
shield. The glass shield must be in place whenever
the oven is in use.
Replacing the oven interior light bulbs:
1. Turn electrical power off at the main source or
unplug the appliance.
2. Remove oven interior light shield as illustrated
below.
3. Replace bulb with a new appliance bulb.
Please note: Do not allow your fingers to touch
the new bulb when replacing. This will shorten
the life of the new bulb. Use a paper towel to
cover the new bulb when installing.
4. Replace glass shield over bulb.
5. Turn power back on again at the main source
(or plug the appliance back in).
6. The clock will then need to be reset.
lift backside
of glass shield
and remove it.
Halogen
Light Bulb
Be sure the range is unplugged and all parts
are COOL before replacing oven light. Wear
a leather-faced glove for protection against
possible broken glass or burns.
IMPORTANT
Most oven doors contain glass that can break.
Read the following recommendations: