Electrolux EI30IF40LS - Manual (Page 17)

Setting Oven Controls 17
Setting the clock
When the appliance is powered up for the first time or when the
electric supply to the appliance has been interrupted, the dis-
play will flash “12:00” (
Figure 28 ).
To set the clock for 1:30:
• Be sure to set the clock to the correct time of day before
using the oven, especially when cooking with added time
instructions.
• The clock cannot be adjusted while the oven is cooking, the
timer is active, or during a self clean.
• If an invalid time of day is entered, the control will sound
with a triple beep (error tone). Re-enter a valid time of day
and press START. If CANCEL is pressed the clock will
automatically set for 12:00.
Changing clock display mode
The oven control is factory preset to display the time of day in
the 12-hour clock setting. The display can be changed to a 24
hour clock setting or to the OFF mode.
When the clock display is turned off it continues to run and will
function based on the previously set 12 or 24-hour setting.
To change clock display modes:
The clock display mode cannot be changed while the oven is
active with any cooking function or during self-clean.
Fig. 28 12:00 displayed when oven is powered up or
power is restored after an interruption
1. Press set clock
2. Enter 130 using numeric keypad 130
3. Press START to accept
START
1. Press and hold set clock for 6 seconds
2. Press set clock to toggle between “12 hr
Day- 24hr day” or “CLO OFF” display
choices. Release key when desired mode dis-
plays (
3. Press START to accept
Fig. 29 Clock set for 12 hour mode
Fig. 30 Clock set for 24 hour mode
Fig. 31 Clock off mode
START