Electrolux EI30IF40LS - Manual (Page 18)

18 Setting Oven Controls
Changing Oven temperature display (°F or °C)
The oven control is factory preset to display oven temperatures
with Fahrenheit (°F) values. The control may be changed to dis-
play temperatures in Celsius (°C) if desired.
To change the temperature display mode:
The clock display cannot be modified while oven is active with
any cooking function or during self-clean operation.
Changing between 12- Hour Energy Saving or
continuous bake mode settings
The oven control is factory preset for a 12 HR Energy Saving
mode. This setting automatically turns off any oven function
after 11 hours and 59 minutes of non-stop cooking. The control
may be set to override this feature if there is a need for cooking
beyond 12 hours.
To change between 12 Hour Energy Saving and continuous
bake settings:
Adjusting tone volume
A tone will sound when a key is pressed and also at the end of a
cycle (timer, cook time. or end time). The factory audio setting is
preset to the highest level (
Figure 34 ). The volume may be
adjusted for lower levels from 1 through 5, or can be turned off.
Level Aud 5 is the highest setting, level 1 is the lowest setting
(
Figure 35 ) and Aud OFF ( Figure 36 ) will provide a silent con-
trol setting.
To adjust the audio tone level :
When the control is set for Aud OFF, error tones will remain
audible.
1. Press and hold BROIL key for 6 seconds.
Release when F or C appears in display.
2. Press BROIL to toggle between F and C
temperature display choices. When the
desired mode appears in the display
release the key.
3. Press START to accept.
1. Press and hold timer on-off for 6 seconds.
Either 12 Hr Off ( Figure 32 )or Stay On
( Figure 33 ) will appear.
2. Press timer again to choose desired setting.
3. Press START to accept.
Fig. 32 Oven set for 12 Hr energy saving mode
Fig. 33 Oven set for continuous operation
START
START
Fig. 34 Tone volume highest level
Fig. 35 Tone volume lowest level
Fig. 36 Tone volume off
1. Press and hold End Time for 6 seconds.
When Aud appears release the key.
2. To choose the different audio level continue
to press End Time to toggle to the desired
audio level and then release the key.
3. Press START to accept
end
time
end
time
START