Electrolux EI30IF40LS - Manual (Page 42)

42 Care and Cleaning
Removing and replacing the oven door
To prevent possible burns, do not attempt to
remove the oven door until the oven has completely cooled.
The oven door is heavy. Be careful when
removing and lifting the door. Do not lift the oven door by the
handle.
To remove the oven door:
1. Open oven door completely ( Figure 78 ).
2. Pull the hinge locks on both left and right hinges down from
the oven frame completely towards the oven door
(
Figure 79 ). A tool such as a small flat-blade screwdriver
may be required.
3. Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle).
4. Close the door to the broil stop position ( Figure 80 ). The
oven door will stop into this position just before fully closing.
5. With the oven door in the broil stop position ( Figure 80 ), lift
and carefully pull the oven door away from the oven frame.
To avoid finish damage, be careful not to allow the oven
door hinges to contact the oven front frame.
To replace oven door:
1. Firmly grasp both sides of oven door along the door sides
(Do not use the oven door handle).
2. Holding the oven door at the same angle as the removal
position, carefully line up and insert both door hinge arms
between the pins located on each side of the oven door
frame (
Figure 81 ).
3. With both door hinge arms in place, open the oven door
( Figure 78 ).
4. Push the door hinge locks up towards and into the oven
frame for both left and right oven door hinges to the locked
position (
Figure 79 ).
5. Close the oven door.
Special door care instructions - Most oven doors contain
glass that can break.
Read the following recommendations:
•
Do not close the oven door until all the oven racks are fully
in place.
• Do not hit the glass with pots, pans, or any other object.
• Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of breakage
at a later time.
Figure 78: Oven hinge locations
Figure 79: Unlocking and locking the hinges
Figure 80: Broil stop position for removing door
Figure 81: Oven hinge and roller pin
LOCK
about
10°
hinge
oven
door
roller
pin
hinge
arm