Electrolux EXP09HN1WI - Manual (Page 13)

ENGLISH 13
OPERATING INSTRUCTIONS
NOTE
The following instructions represent the
Control Panel, the same instructions can
be used for the Remote Control.
COOLING MODE:
In this mode the exhaust adaptor
hose MUST be used.
1. Press the MODE button until the
"Cool" indicator lights.
2. Press the " " Temp buttons for
desired setting.
3. Press the FAN button for desired fan
speed.
HEATING MODE: (on some models)
In this mode the exhaust adaptor
hose MUST be used.
1. Press the MODE button until the
"Heat" indicator lights.
2. Press the " " Temp buttons for
the desired heat setting.
3. Press the FAN button for desired fan
speed.
4. Connected drain hose. See drainage
section.
DRY MODE:
In this mode you do not need to use
the exhaust adaptor hose, BUT the
water collected must be discharged.
See Drainage Section.
1. Press the MODE button until the
"Dry" indicator lights.
2. The fan will run at low speed and
the display will show the room
temperature.
3. Keep doors & windows closed for
best effect.
AUTO MODE:
Always have the exhaust hose
attached in this mode.
When you set the air conditioner in
AUTO mode, it will automatically select
cooling, heating(inapplicable for cooling
only models), or fan only operation
depending on what temperature
you have selected and the room
temperature. The air conditioner will
control room temperature automatically
round the temperature point set by you.
Under AUTO mode, you can not select
the fan speed.
FAN MODE:
In this mode there is no need to use
the exhaust hose or drainage hose.
However, if you require stale or
smokey air to be removed from the
room, hook up the duct accessories
as described in the "EXHAUSTING
HOT AIR" section.
1. Press the MODE button until the
"Fan" indicator lights.
2. Press the FAN button to choose the
desired fan speed.
3. The fan will run at the selected
speed and the display will show the
room temperature.
TIMER OPERATION:
You can set both delay stop and delay
start while unit is in ON position or OFF
position. When unit is in ON position,
first press TIMER button to go to delay
stop setting, then "timer off" light will
illuminate, tap or hold the UP arrow (
)
or the DOWN arrow ( ) to change delay
stop timer at 0.5 hour increments up
to 10 hours, then at 1 hour increments
up to 24 hours. Then press the TIMER
button to confirm the setting (the control
will confirm the setting automatically after
5 seconds) and go to delay start setting.
Use the same way as above to set the
delay start timing. If you don't need to
set delay start, press the TIMER button
again to exit. After 5 seconds, the control
will automatically change the display
back to previous temperature display.
If you want to check remaining time,
press the TIMER button. The delay start
operation automatically selects mode,
temperature and fan speed the same as
last operation you set.
To activate the Timer function when the
unit is in Off mode, press TIMER button
to first enter delay start and secondly
enter delay stop in the same way as
above.
To cancel the timer setting, simply tap
(
) or ( ) button to change the timing
to 0.0.