Electrolux EXP09HN1WI - Manual (Page 10)

10 www.electrolux.com
8"--
%*4$)"3(&
Mount wall adaptor directly over
correctly installed duct to outside. (This
usually includes aluminum wall ducting
& an outside cover. See your hardware
specialist for correct installation.) Use
wall plugs & screws to secure. (Fig. 10)
Attach hose duct to wall adaptor.
Screws &
Wall Adaptor
Max 48"
Mix 12"
Screws
& Wall
Plugs
Fig. 10
The hose can be extended from
its original length of 38.1cm up to
139.7cm, but it is the best to keep the
length to minimum required. Also make
sure that the hose does not have any
sharp bends or sags. (Fig. 11)
Fig. 11
Installation in a double-hung
sash window
1. Cut the foam seals(adhesive type) to
the proper lengths and attach them
to the window and stool. (Fig. 12)
Foam seal A
(adhesive type)
Foam seal A
(adhesive type)
Fig. 12
2. Open the window sash and place
the window slider kit on the window
stool (Fig. 13). Attach the window
slider kit to the window stool. Adjust
the length of the window slider kit
according to the width of window.
Screw down the two screws on the
window slider kit. See Fig.13. Cut
the adjustable window slider kit if
the width of window is less than
26.6 inches (Fig. 14).
Window slider kit
Window stool
26.6"~48.5"
screws screws
26.6"~48.5"
Window slider kit
Window stool
Fig. 13
Cut this side to fit your window Cut this side to fit your window
Fig. 14
3. Close the window sash securely
against the window slider kit. (Fig. 15)
4. Drive two 1/2" screws to secure
the window slider kit to the window
sash. (FIG. 15)
5. Secure the window slider kit to the
window stool (FIG. 15):
A: For wooden windows: Use 3/4"
screws for securing.
B: For Vinyl-Clad windows: Use
1/2" hex head cap screws for
securing.
hex head cap screws
3/4˝ screws or 1/2˝
1/2˝ screws
Window slider kit
Window stool
1/2" screws
3/4" screws or 1/2"
hex head cap screws
Window slider kit
Window stool
Fig. 15