Electrolux EXP09HN1WI - Manual (Page 14)

14 www.electrolux.com
SLEEP OPERATION:
In this mode the selected temperature
will increase by 1 °C 30 minutes after
the mode is selected. The temperature
will then increase by another 1 °C after
an additional 30 minutes. This new
temperature will be maintained for
7 hours before it returns to the originally
selected temperature. This ends the
"Sleep" mode and the unit will continue
to operate as originally programmed.
The "Sleep" mode program can be
cancelled at any time during operation
by again pressing the "Sleep" button.
Note: This feature is unavailabe under
FAN or DRY modes.
SWING OPERATION:
When you turn on the unit, the louver
will swing and stop at a certain angle.
You can press the SWING button to let
the louver swing automatically. Press
the SWING button again while you want
the louver stop at desired angle.
FAULT CODE:
If the display reads "E1", the room
temperature sensor has failed. Call for
service.
temp/timer setting
If the display reads "E2", the evaporator
temperature sensor has failed. Call for
service.
temp/timer setting
If the display reads "E3", the condenser
temperature sensor has failed. Call for
Service.
temp/timer setting
If the display reads "E4", the display panel
communication has failed. Call for sen/ice.
temp/timer setting
If the display reads "P1" , bottom tray
is full. Carefully move the unit to a drain
location, remove the bottom drain plug
and let the water drain away. Restart the
machine until the "P1" symbol disappears.
If error repeats, call for service.
temp/timer setting
DRAINAGE:
1. During the dehumidifying mode,
you will need a garden hose (sold
separately) to drain the condensate
from the unit. Remove the rubber
stopper from the hose connector,
then screw on a garden hose to the
connector as shown on fig 25.
The hose may then:
A. Discharge into a drain that is lower
than the unit.
B. Be connected to a condensate
pump (sold separately).
Remove the
supplied rubber
stopper
Garden hose
&IGÒ
Garden hose
Remove the
supplied rubber
stopper
2. During the Heating mode, you will
need to connect a drain hose to the
rear of unit as Fig.26
&IGÒ
Continuous
drain hose
Continuous
drain hose