Audiovox PAV-8000D - Manual (Page 11)

10
Table 1. System Setup Values
Setup Item: Range Default Value
1 Clock Mode 12H/24H 12H
2 Panel Detachable ON/OFF OFF
3 Beep ON/OFF ON
4 Clock Display ON/OFF ON
5 Light In ON/OFF ON
6 LCD Flash Mode 0~14 14
7 LCD Contrast 0~7 2
5.6. Select BASS, TREBLE, BALANCE and PLAYBACK Mode
Press the (SEL/LOC) button
6
to select the Audio modes as shown is the following sequence:
Figure 11. System Playback Mode Setup
5.6.1 Bass and Treble Control
Once either Bass or Treble is selected, rotate the (SEL/LOC) knob
6
to Increase (Right) or Decrease (left)
the Bass/Treble.
Figure 12. (SEL/LOC) Button
5.6.2 Balance and Fader Control
Press the (SEL/LOC) button
6
? to select Left & Right Balance mode. Once in the Balance mode, rotate the
(SEL/LOC) knob
6
? to balance between the Left and Right speakers. Press the (SEL/LOC) button
6
again
to select the fader mode . Once in the Fader mode, rotate the (SEL/LOC) button
6
? to balance between the
Front and Rear speakers
5.6.3 Sound Effect Control
Press the (SEL/LOC) button
6
? to select the SOUND Effect. Once in SOUND Effect mode, rotate the
(SEL/LOC) knob
6
? to switch between the different sound effects as shown is the following sequence :
NORMAL à FLAT à JAZZ à ROCK à CLASSIC à PO P
5.6.4 Loudness Control
Press the (SEL/LOC) b utton
6
? to select Loud then rotate the knob to switch the Loudness control ON and OFF.
6
SOUND NORMAL à VOL à BASS à
LOUDNESS ß FADER ß BAL ßTRE
6