Audiovox PAV-8000D - Manual (Page 22)

21
6. INSTALLING THE PAV-8000D SYSTEM
Before installing the PAV-8000D verify that the Radio antenna and speakers are operational and are perform ing
well. Disconnect power supply cable from the connecting terminal of the vehicles Battery.
CAUTION: When disconnecting the Battery Negative (-) Connecting Terminal, vehicles equipped with cruise
equipment or a satellite navigator will lose all preset memory.
6.1. Front Panel Installation
6.1.1. Cautions During Installation
If possible, have qualified personnel install the PAV-8000D system.
The PAV-8000D system is intended for installation in vehicles with DC 12V Negative Ground battery systems.
Make all electrical/electronic connect ions as directed in this manual. Incorrect connection may damage the
equipment and will void the warranty. Carefully read the Instruction Manual and Installation Specification before
installation.
6.2. Accessories and Hardware
Table 2. Installation Hardware
No. Item Diagram Quantity No. Item Diagram Quantity
1
Mounting
sleeve
1 7
Front Panel
Case
1
2 Hex bolt 1 8
Remote
control
1
3 Rear Strap 1 9
Decorating
Panel
1
4
Mounting
screw
1 10 Battery 1
5 Bolt 1
6 Power
connector 1
6.3. System Installation
6.3.1 Installation Procedure
1. Install the Mounting Bracket (1) by inserting the Bracket into dashboard and bend the mounting tabs
outwards with a screwdriver so that the bracket is tight.
Figure 47. Mounting Bracket Installation