Audiovox PAV-8000D - Manual (Page 23)

22
2. Install the PAV-8000D unit
a. Check that all connections are correct.
b. Install the mounting bolt (5).
c. Insert main connector (6) into the rear of the unit.
d. Insert the PAV-8000D unit into mounting Bracket (1) and gently push it in until it locks in -place (a
“click” sound will be heard).
e. Use the following recommended method to anchor the rear of the PAV-8000D unit.
1. Fasten one end of the Rear support Strap (3) to the rear of the PAV-8000D unit.
2. Fasten the other end of the Rear support Strap (3) to the firewall or other sturdy non-moving metal
parts of the vehicle.
6.3.2 Electric Connections
l Power supply for the unit is DC 12V negative (-) ground.
l Connect the unit according to the following wiring diagram to avoid damage.
l Do not insert in power supply connector before finishing connections.
l Do insulate any exposed cables.
Cables Connection
REAR (L)
FRONT(L)
BROWN
BLACK
GND
GREEN/BLACK PURPLE/BLACK
GREEN
WHITE/BLACK
WHITE
PURPLE
GRAY/BLACK
GRAY
REAR (R)
FRONT (R)
LIGHT
FILTER
RED
BLACK
ACC
YELLOW
12V
WHITE
BLUE
BLACK
TEL-MUTE
AUTO-ANT
REMOTE
Figure 48. Cables Connection Diagram A
CDC
ANT
LINE OUT VIDEO OUT
REAR R CENTER REAR L FRONT L FRONT R
YELLOW YELLOW
WHITE
RED
WHITE
RED
GREY
BROWN
SUB-W VIDEO-2 VIDEO-1
Figure 49. Cables Connection Diagram B