Configuring the ip phones – Aastra Telecom SIP 57I User Manual
Page 202
Global SIP Settings
4-78
41-001160-00, Release 2.1, Rev 04
IP Phone Administrator Guide
Configuring the IP Phones
2
Do one of the following actions:
•
To allow this line to use the global autodial settings, click on the Use Global Settings parameter
to enable it, then click
to save your changes.
•
To specify a different autodial configuration for this specific line, disable the Use Global
Settings parameter. Then proceed to step 3.
3
In the “Autodial Number” field, specify the SIP number for this line that the IP phone dials
whenever the IP phone is off-hook as follows:
•
If set to -1, then the global autodial settings for this IP phone to this line.
•
If set to empty (blank), then disable Autodial on this line.
•
If set to a valid SIP number, dial the SIP number specified for this line. For example: 8500
4
In the “Autodial Timeout” field, specify a value, in seconds, for the timer for this line as follows:
•
If you want the IP phone to autodial the number immediately (hotline) whenever the IP phone is
off-hook, accept the default value of 0.
•
If you want to specify a length of time for the IP phone to wait before dialing the number, enter
the length of time (in seconds). For example: 30
Valid values are 0 to 120.
5
Click
to save your changes.
Aastra Web UI