Adaptec AMM-1572 - Manual (Page 71)

4-7
Troubleshooting
AMM-1570/1572 User’s Guide
Stock Number: 510526-00, Rev. B
Page: 4-7
Print Spec Number: 492379-00
Current Date: 3/7/94
ECN Date: 3/8/94
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
A
A
A
A
A
A
A
A
A
A
A
A
A
A
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
AAAA
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
While playing audio CDs from your CD-ROM drive, you can not hear
any sound while plugged into the SPKR jack on the AMM-1570/1572,
but if you plug into the audio/headphone jack on the CD-ROM drive it
works fine.
■ A separate audio cable provided by the CD-ROM manufacturer
must be connected from the Line-level Output (Audio Out)
connector on the CD-ROM drive to the CD Audio Input con-
nector (J4) on the AMM-1570/1572. Refer to Line-in (IN) Jack on
page 3-18.
ASPI Manager Error Messages
This section list error messages and the conditions which they may
be displayed.
aspi2dos.sys Error Messages
Failed to initialize HA
Check the host adapter and reinstall if necessary. Check jumpers and
cables.
aspi2dos.sys Installation Failed
Check the contents of your config.sys file. Remove all unnecessary
device drivers (including all memory managers) until aspi2dos.sys
installs successfully; then reload the other drivers one at a time to
find the driver that is causing the problem. Try installing
aspi2dos.sys on the first line of your config.sys . file.
Illegal or no Hex Digit Found on command line option
Illegal Digit Found on command line /
x option
Check the syntax of the statements in your config.sys file. There may
be an invalid digit on the command line.
aspidisk.sys Error Messages
aspidisk.sys is NOT installed
Check the contents of your config.sys file. Remove all unnecessary
device drivers until aspidisk.sys installs successfully; then reload the
drivers one at a time to find the driver that is causing the problem.
Be sure that the disk device you want to control with aspidisk.sys is
not under the control of the host adapter BIOS. (If enabled, the host
adapter BIOS controls the SCSI drives installed at SCSI IDs 0 and 1,
and
aspidisk.sys is not required.)