LG LRE3091SW - Manual (Page 11)

2 2
1
A B
11
ENGLISH
S U R FAC E C O N T RO L S C O O K I N G
SETTING SURFACE CONTROLS
Use to turn on the surface elements. An infinite choice of heat settings is available from Low to High. The knobs can
be set on or between any of the settings.
ᕡ
Place pan on surface element.
ᕢ
Push in and turn the knob in either direction to the
desired heat setting.
• The control panel is marked to identify which
element the knob control. For example, the
graphic above indicates left front element.
ᕣ
There is an element indicator light on
the control panel. When any surface
control knob is turned on, the light will
turn on. The light will turn off when all the
surface elements are turned off.
ᕤ
After cooking, turn knob to OFF. Remove pan.
Dual Element (select modes)
The cooking surface has a dual element located at
the right front of the smoothtop. This allows you to
change the size of the element.
The small element is operated on the left side of the
knob control. To operate the entire element, use the
right side of the knob control, The control for both
element sizes can be set anywhere between Low and
High.
Heating with inner
(smaller) element only
A B
Heating with both
element together
• NEVER leave food unattended at high or
medium-high setting.
- Boilovers can cause smoking and greasy
spillovers may catch on fire.
CAUTION
• DO NOT touch surface elements until they
have cooled down sufficiently.
- The surface elements may still be hot and burns
may occur.
CAUTION
• Use only cookware and dishes recommended
as safe for oven and cooktop use.
• Always use oven mitts when removing food
from the surface element as cookware and
plates will be hot.
• When warming foods do not use containers
that seal. Allow venting for heated air to
escape.
• Do not use plastic wrap to cover foods.
- Plastic may melt onto the surface and be very
difficult to clean.
CAUTION
To turn on a dual surface unit
(Right Front) To turn on a single surface unit
(Left Front, Left Rear, Right Rear)
2
1
2