LG LRE3091SW - Manual (Page 29)

29
ENGLISH
O P E R AT I N G I N S T R U C T I O N S
If it becomes necessary to stop or interrupt a self-
cleaning cycle due to excessive smoke or fire in the
oven: When the self-clean cycle is done
• It will not be possible to open the oven door until
oven temperature has cooled.
• It is recommend to use 2 hour self-clean cycle for
light soil, 3 hours cycle for average soil, and 4 hours
cycle for heavy soil.
• Additional time is needed to cool the oven down.
Therefore, the oven door will not release from the
lock position until after it has cooled.
NOTE:
• The hot surface indicator will display on the cooktop
during the Self Clean cycle.
After the Self-Clean cycle
• You may notice some white ash in the oven. Wipe it
off with a damp cloth or a soap-filled steel wool pad
after the oven cools.
These deposits are usually a salt residue that cannot
be removed by the clean cycle.
If the oven is not clean after one clean cycle, repeat
the cycle.
• If oven racks were left in the oven and do not slide
smoothly after a clean cycle, wipe racks and rack
supports with a small amount of vegetable oil to
make them glide easier.
• Fine lines may appear in the porcelain because it
went through heating and cooling. This is normal and
will not affect performance.
ᕡ
Touch CLEAR/OFF.
ᕢ
After the oven has cooled down, the
DOOR LOCK will automatically
release allowing you to open the
oven door.
SELF-CLEAN
(cont.)
NOTE:
When using the Self-Clean feature:
• A Self-Clean cycle cannot be started if Oven
Lockout feature is active.
• Once the SELF CLEAN is set, the oven door will
lock automatically. You will not be able to open the
oven door until the oven is cooled. The lock will
release automatically.
• Once the door has been locked the LOCKED
indicator light will stop flashing and remain on.
Allow about 15 seconds for the oven door lock to
close.
• If your clock is set for normal 12 hours display mode
the Delayed Self-Clean can never be set to start
more than 12 hours in advance.To set for a delayed
Self-Clean cycle 12- 24 hours in advance, see page
19 for instructions to set the control for the 24 hours
time of day display mode.