Important safety informations, Caution – LG LUV400T User Manual

Page 5

Advertising
background image

5

ENGLISH

IMPORTANT SAFETY INFORMATIONS

• Do not put any objects into openings.

Failure to do so could result in product damage.

• Do not use with any opening blocked: keep free of dust, lint,

hair, and anything that may reduce air flow.

Failure to do so could result in product damage.

• Do not use vacuum cleaner without dust tank and/or filters

in place.

Failure to do so could result in product damage.

• Always clean the dust tank after vacuuming carpet cleaners

or fresheners, powders and fine dust.

These products clog the filters,reduce airflow and can cause

damage to the cleaner. Failure to clean the dust tank could cause

permanent damage to the cleaner.

• Do not use vacuum cleaner to pick up sharp hard objects,

small toys, pins, paper clips, etc.

They may damage the cleaner or dust tank.

• Store the vacuum cleaner indoors.

Put the vacuum cleaner away after use to prevent tripping over it.

• The vacuum cleaner is not intended to use by young

children or infirm people without supervision.

Failure to do so could result in personal injury or product damage.

• Only use parts produced or recommended Electronics

Service Agents.

Failure to do so could result in product damage.

• Use only as described in this manual. Use only with LG

recommended or approved attachments and accessories.

Failure to do so could result in personal injury or product damage.

• To avoid personal injury and to prevent the machine from

falling when cleaning stairs, always place it at the bottom of

stairs.

Failure to do so could result in personal injury or product

damage.

• Make sure the filters (exhaust filter and motor safety filter)

are completely dry before replacing in the machine.

Failure to do so could result in product damage.

• Do not dry the filter in an oven or microwave.

Failure to do so could result in fire hazard.

• Do not dry the filter in a clothes dryer.

Failure to do so could result in fire hazard.

• Do not dry near an open flame.

Failure to do so could result in fire hazard.

• Always turn vacuum cleaner off before connecting or

disconnecting the hose.

Personal injury or product damage could result.

• Your vacuum cleaner is intended only for household use.

• Proper assembly and safe use of your vacuum cleaner are

your responsibilities.

• Do not put the finger between crevice tool and cord hanger,

when take out the crevice tool.

• Hose storage consist of two strong magnetic. Keep away

electronic equipment or dangerous steel things from hose

storage.

CAUTION

Thermal protector :

This vacuum cleaner has a special thermostat that protects the vacuum cleaner in case of motor overheating. If the vacuum

cleaner suddenly shuts off, turn off the switch and unplug the vacuum cleaner.

Check the vacuum cleaner for possible source of overheating such as a full dust tank, a blocked hose or clogged filter. If these

conditions are found, fix them and wait at least 30 minutes before attempting to use the vacuum cleaner. After the 30 minutes period,

plug the vacuum cleaner back in and turn on the switch. If the vacuum cleaner still does not run, contact a qualified electrician.

The Federal Communications Commission Radio Frequency Interference Statement includes the following warning:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, can radiate radio frequency energy and if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC (RSS-210) Rules.

Operation is subject to the following two conditions:(1)This device may not cause harmful interference and (2) this device must accept any

interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must

not be co-located or operating in conjunction with any other antenna or transmitter.

Transmitter specification

* Carrier frequency: 2456, 2463, 2470 MHz * RF output power : 0 dBm

Any changes or modifications in construction of this device which are not expressly approved by the party

responsible for compliance could void the user’s authority to operate the equipment.

CAUTION

Advertising