LG LUV200R - Manual (Page 23)

Review this chart to find do-it-yourself solutions for minor performance problems.
Any service or repair needed, other than as described in this User’s Guide, should be performed through
your local LGE service center.
Electrical shock and personal injury hazard.
Always unplug the vacuum cleaner before servicing.
Failure to do so could result in electrical shock or personal injury.
WARNING
PROBLEM
Vacuum cleaner
will not run
Poor dirt pickup
Agitator does not
turn
• Unplugged at wall outlet.
• Agitator motor overload
protection activated.
• Thermal overload protection
activated.
• Full or clogged dust tank.
• Dust tank improperly installed.
• Clogged hose or wand.
• Belt broken/not installed properly.
• Agitator motor overload protection
activated.
• Hole in hose.
• Worn agitator.
• Switch is off.
(unit is in bare floor mode)
• Cleaner is in upright position.
• Agitator motor overload protection
is tripped. (brush is jammed)
• Belt is broken.
• Make sure cord is plugged into a functioning
outlet.
• Allow the vacuum cleaner to cool down.
[See page 14]
• Empty dust tank and clean filters.
[See page 16,17,18]
• Make sure all dust tank components and
filters are installed correctly.
• Check for clogs. [See page 20]
• Check belt and replace if needed.
[See page 19]
• Unplug the vacuum cleaner and check the
agitator for obstructions.
Press the reset button. [See page 14]
• Inspect hose carefully. Replace if needed.
• Contact service.
• Turn on agitator power switch.
[See page 10]
• Press the Body release and tilt unit back.
[See page 10]
• Unplug the vacuum cleaner and check the
agitator for obstructions and reset the unit.
[See Page 14]
• Unplug the vacuum cleaner and check the
agitator for obstructions and reset the unit.
[See Page 14]
• Replace belt. [See page 18,19]
POSSIBLE CAUSE POSSIBLE SOLUTION
TROUBLESHOOTING
22