LG LUV200R - Manual (Page 24)

TROUBLESHOOTING
PROBLEM
• Dust tank improperly installed.
• The dust tank lid not closed.
• The bottom plate is not latched.
• Wrong pile height setting.
• Dirty agitator or agitator supports.
• Obstruction in turbine air path.
• Low suction from vacuum cleaner.
• Cleaner is not in upright position.
• The plug cord is tangled.
• Make sure all dust tank components and
filters are installed correctly.
• Check the dust tank lid.
• Make sure the bottom plate is closed and
latched.
• Adjust pile height. [See page 11]
• Clean the inside of the pet hair turbine tool.
[See page 18]
• Clean the inside of the pet hair turbine tool.
[See page 18]
• Check for clogs. [See page 20]
• Keep the cleaner in upright position.
• Try to rewind the plug cord again after
pulling it all the way out.
• Firmly pull plug cord to release it from cord
reel.
POSSIBLE CAUSE POSSIBLE SOLUTION
Dust escapes the
dust tank
Cleaner picks up
moveable rugs or
is hard to push
Agitator on Pet
hair turbine tool
will not run when
attached
Accessory has
no suction when
using with the
handle
Plug cord will not
rewind or pull to
desired cord length.
23
ENGLISH