Agilent Technologies AGILENT U2761A - Manual (Page 80)

62 U2761A User’s Guide
2 Features and Functions
Soft Front Panel Operation
Click Mod and then select PM as shown in
Figure 2- 20 . To output the PM waveform, configure the
settings for the carrier frequency, output amplitude, offset
voltage, modulating frequency, phase deviation, and the
desired waveform.
Figure 2-20 Panel view of PM
Remote Interface Operation
PM:STATe {0|OFF|1|ON}
Carrier Waveform
The PM carrier waveform consists of Sine, Square, Ramp,
Triangle, or Arbitrary waveform. The default waveform is
Sine wave. You cannot use Pulse or DC as the carrier
waveform.
Soft Front Panel Operation
For Arbitrary waveforms, click Arb at the top panel
as shown in Figure 2- 2 and select the desired waveform
from the drop down list as shown in Figure 2- 16 .